Okay, so one of the wires is connected to vcc, the other to the gpio pin. You use a 10k pull down resistor (gpio to gnd) If that's your setup you should disable the pull-up in the switch settings. I did and now it's good thank you... Now, one more problem :cry: How can I have this level indicator i...

Hi, I wanted to make what I thought an easy project ! I'd like to use a simple water level sensor( https://fr.aliexpress.com/item/1pc-Tank-Pool-Water-Level-Liquid-Sensor-Float-Switch-Brand-New/32581638779.html?spm=2114.13010608.0.110.hXHfTB ) with an ESP01 and Domoticz. I'd like to know if the water...

I Finally used a serial command ...
I used arduino IDE serial monitor and used "Settings" command ... I could read the configuration, the IP adress and set another one...A no given by DHCP !
Thank you for your help ...

rkoppen wrote:Maybe a stupid question but did you arrange for a fixed ip address ?

Did it end up in a different IP because it shut down ?

No more IP... I did a IPscan... that's why I wanted to flash once more

mgennip wrote:I found a solution;

When connecting Tx and Rx together during bootup, it will bring ESP to it's virgin state. After that, you can see ESP_0 in your AP list and connect to it.

Unfortunatly this doesn't work at home !!

mgennip wrote:I know it is possible to reset to system defaults by giving the 'reset' command via the serial interface.
ESP will then appear as ESP_0 just like a new flashed ESP.

Could you please tell me how ?

Hello, I flashed Easy Esp RT108 on a Wemos D1 Mini. All as correct and I could use it with any sensors and domoticz. After Playing with it all the day I switched the power off. This morning I wanted to try news things... The problem is that I can not access my Wemos in my webbrowser... the IP adress...

I'm using Wemos DI with Easy ESP... First configuration went right. Later I wanted to access the web interface in my browser with IP adress and I ' m prompted tu enter a password .... I tried "configesp" ( as the first time) but It is not correct... I try to setup once again Easy ESP on my...