- The sensor has original cable length as it was on SoMoSe v2.2 with total length of 60cm. - I can not detect any pull-up resistor on SDA/SCL. - SDA (D2) and SCL (D1) are connected correctly in same order as the "old" SoMoSe v2.2. - The sensor is a prototype which was send me from the inve...

You are so great, now I can choose BeFlE v3.x ;) But I can not read any values. I2C scan says 0x01 is connected and if I disconnect the v3.4 sensor then there's no result in I2C scan. Without option "Force Slow I2C speed": no value and no log entry. With option "Force Slow I2C speed&q...

That's the MQTT Controller:

I only need the BeFlE Somose v2.2, v3.x , the Analog input - internal and MQTT/WiFi connection.

@Ath Thank you very much for the pull request. I would like to test it but I am not able to get it running and to select the new BeFlE sensor. I successively flashed the following Binaries and am not able to select BeFie v3.x: 1) ESP_Easy_mega_20240509_climate_ESP8266_4M1M.bin 2) ESP_Easy_mega_20240...

The new sensor will be released end of May. See https://github.com/BeFlE/SoMoSe/issues/ ... 2096156495

I am really on the lowest level of programming concerning hardware in EspEasy. I only know the basiscs of rules to control my ESP

There will be a new low power version of the BeFlE Somose sensor released. This sensor needs new logic to work. Can anybody please tell me how to adjust the code of the P047 module to get the new sensor working? Here are the changes of the Arduino implementation of the new sensor: SoMoSe_Arduino.h h...

I just tried: If you change the I2C address by ESP Easy then this will be a permanent setting for the BeFIE. Running two sensors on one Wemos D1 mini on different addresses the address change will be permanent and survive a reboot (or cut off voltage).

GREAT

Is it possible to use multiple BeFIE moisture sensors with one Wemos D1 mini? Each Sensor gets it's own I2C adress and all of them connected to the same GPIO pins.

Or is only one sensor of one type supported by the firmware?

3.3V instead of 5V seems to be the solution. Now I have really consistent readings which seems to be true if nothing changes.

Thank you for the fast good support

Thank you. I2C scan Said "No devices". I reattached the cable and now it's measuring without resoldering. Values are a bit off, i.e. temperature about +6°C. Moisture weg is around 140 which should be 100 as maximum. Is it possible to calibrate the Sensor via ESP Easy? I have a few "Tr...

I how flashed the Collection_C Firmware and configured BeFIE Sensor AS device. SDA: GPIO-4 (D2) and SCL: GPIO-5 (D1) but I get no readings. Voltage of the sensor ist connected correctly to 5V of the Wemos D1 mini.
What ist going wrong? How can I debug it?

So the build ESP_Easy_mega_20230822_collection_C_ESP8266_4M1M.bin would be the right one?

It's a little bit difficult if you are new to EspEasy...

Which release binary I have to flash to get the BeFlE moisture sensor on a Wemos D1 mini?

If I flash the current one ESP_Easy_mega_20230822_normal_ESP8266_4M1M.bin I can not see any device Environment - Soil moisture sensor.