Hello all

i try to get an folder after root.
but i am not sure how the correct syntax will be ?

i did try :

Testbereich
/Testbereich
/Testbereich/

but nothing worked so far

here is a screenshot: thank you so much for your help
Sascha

thank you for your answere.

this worked once and i got the message (one step further)
but after the command the ESP freezed and i had to do a hard reset.

Sascha

EDIT: i did it a few times and always after send the command from tools form the ESP freezed.

hello all :) i am still a little fighting on my side here. Could someone give this a try with a newer version like 201809xx : on System#Boot do Monitor GPIO,0 Monitor GPIO,4 Monitor GPIO,5 Monitor GPIO,16 timerSet,1,30 endon on GPIO#16=1 do SendToHTTP 192.168.123.10,8080,/json.htm?type=command&p...

ok.....i just did try mega-20180826.....

and there is everything i need working very well......

So something with HTTP seems to be not working in the newer versions.....

Sascha

ok....what about we forget Uptime and controller for a moment...... At the moment i am confused where the problem is.....good chance it is me.... Can someone proof this: rule: on System#Boot do Monitor GPIO,16 endon on GPIO#16=1 do //SendToHTTP 192.168.123.10,8080,/json.htm?type=param=switchlight&am...

well,

i use IP-Symcon Houseautomation Software on the other side...

With 20180908 everything works fine.
But there is a glitch i can´t send http commands by using rules.

it is the first node and the first connection to IP-Symcon

ok....i really dont get it at the moment...... I have done a fresh install and fresh config with 20180914 right now. I try to just send "uptime" to http Dominicz Controller. When i enable the controller all Systeminfos are freezed. Do i something wrong ? The goal would be to recieve uptime...

HAHAHAHAHAHA !!! good point !!!

btw......you guys do an amazing job..... i know ESPEasy since yesterday......but in my head millions of ideas popping up what i can do in future !!!

for now getting feedback about the state of my relays would be enough

cheers
Sascha

very unusual !!!

99% of all problems i run into it comming from about 30 inch in front of my screen

ok....at the moment i dont save or load a settings file......i start from scratch always. but i think you mean, the settingfile which will be created and modify always you press the "Submit" button ? So then i call it a day......i did try to get it to work the whole day :) i´ll wait untill...

ok....i will read :) as always :) but something isn´t going well at the 20180910 version at all...... At the moment i use smalles possible thing... Sending uptime task to controller via Domoticz uptime freezes after i set up the controller 192.168.123.10 port 1024 Can you somehow confirm this ? it w...

ok....i am still a little fighting....it was working a few minutes.....then uptime is now freeze at "0" minutes.... a wonderful beginner question: which image do i need for my NodeMCU lolin ? Where ist the different between normal,4096 and dev,4096 ? Is there a page i can read about it ? T...

You made my day it worked

Thank you very much !

Hello all, i did research for hours and now i have to post my question(s) in here.... i came from 20180908 ESPEasy Mega and did an upgrade to 20180910 because i need to send HTTP messages back to controller..... Hardware is an NodeMCU Lolin. The image i took was "normal,4096" After upgrade...