Becker motors

Post here about devices that are not yet or not fully supported

Moderators: rtenklooster, Voyager, BertB, Stuntteam

Post Reply
Message
Author
janiszewskit
New user
Posts: 2
Joined: 09 May 2018, 13:09

Becker motors

#1 Post by janiszewskit » 09 May 2018, 13:21

Hello

I have Becker blinds with motors like "Becker Rohrmotor Funk P9-C01 - P9/16C PROF+ - 9 NM". (https://www.caliso.de/becker/rohrmotor- ... -9-nm-4897)
These are radio engines
The communication is at a frequency of 868 MHz

So...

I wanted to buy RFLink 868.3 OOK Gateway componenten (https://www.nodo-shop.nl/nl/rflink-gate ... enten.html) but I do not know if it will work with my motors.

On page : http://www.rflink.nl/blog2/devlist not found any backer motors :(.

I want everything connect to my Domoticz system.

Can anything help me in this matter ?

mdieli
New user
Posts: 1
Joined: 24 Jun 2018, 21:47

Re: Becker motors

#2 Post by mdieli » 24 Jun 2018, 21:51

Hi,

I have a remote from Becker (Centronic EasyControl EC545) to operate my blinds.
I am also eager to know if the RFLink is working with the remote/receivers?

Thank you in advance!

janiszewskit
New user
Posts: 2
Joined: 09 May 2018, 13:09

Re: Becker motors

#3 Post by janiszewskit » 25 Jun 2018, 09:40

Hello
I have TC4410-II for my blinds.

I bought rf-link 868 from https://www.nodo-shop.nl/en/rflink-gate ... nents.html with antenna.

I'm trying to do anything. For now in serial port i have many information, but I do not understand them very much ;(

ccaru
New user
Posts: 1
Joined: 20 Feb 2019, 15:22

Re: Becker motors

#4 Post by ccaru » 20 Feb 2019, 15:25

Hello, I too would like to build an 868MHz RFLink to use Domoticz to control Becker motors.
Can anybody help with how one can go about developing this?

Post Reply

Who is online

Users browsing this forum: No registered users and 14 guests