My plan was to catch weather information from my old outdoor La Crosse TX-2U sensor, but for some reasons I see nothing in the debug log. I expected to see either something decoded or at least some raw debug data, but I see nothing [from the sensor].
Code: Select all
20;00;Nodo RadioFrequencyLink - RFLink Gateway V1.1 - R45;
10;version;
20;01;VER=1.1;REV=45;BUILD=09;
10;status;
20;02;STATUS;setRF433=ON;setNodoNRF=OFF;setMilight=OFF;setLivingColors=OFF;setAnsluta=OFF;setGPIO=OFF;setBLE=OFF;setMysensors=OFF;
10;rfdebug=on;
20;03;RFDEBUG=ON;
I used the same Arduino, same receiver (YXR15), same pins and even cables with a sketch called TX6U-Monitor I found somewhere. With that sketch I was able to catch some data from the sensor. The actual values received were wrong though. The only change I made for RFLink was the power line - I moved this wire from 5V to Pin 16.
Looking for ideas/suggestions.
Thanks!