Nothing received by RFLink on 433MHz

[gslapp]

Hi folks,

I bought the RFLink kit, including the Arduino Mega 2560 and 433MHz kit board. After assembling it and linking to my Domoticz setup running on a Raspberry Pi I wasn't able to locate any devices.

Thinking I had stuffed up the soldering of the 433MHz board, I ordered a new one from the Nodo Shop, but this time with the solder service. However I still cannot see anything logged.

I've tried debug mode in the RFLink Loader and can see the initial status messages, but nothing seems to be picked up. I've also tried debug mode in the Loader but, again, nothing.

Code: Select all

20;00;Nodo RadioFrequencyLink - RFLink Gateway V1.1 - R46;
20;01;MySensors=OFF;NO NRF24L01;
10;version;
20;02;VER=1.1;REV=46;BUILD=0c;
10;status;
20;03;STATUS;setRF433=ON;setNodoNRF=OFF;setMilight=OFF;setLivingColors=OFF;setAnsluta=OFF;setGPIO=OFF;setBLE=OFF;setMysensors=OFF;
10;rfdebug=on;
20;04;RFDEBUG=ON;

The devices I have that are on 433Mhz are a Friedland wireless doorbell and a LightwaveRF remote (complete with the LightwaveRF hub and 3 sockets).

I'm not sure if it's relevant, but I also have an RFXCOM RFXtrx433E connected to Domoticz (which works fine).

Any thoughts what might be going wrong here?

Many thanks,

Graeme

[Peter@andersson.me]

Hi im having the exact same issue (but i haven't ordered a new one yet), might i ask what antenna are you using? i have only tried with the RFXCom antenna..

I posted viewtopic.php?f=12&t=3419 in case some one answers there it might help you also!

[gslapp]

Hi Peter,

I'm using the SMA antenna that came with the kit from the Nodo Shop.

https://www.nodo-shop.nl/en/antennes/12 ... -nodo.html

Not tried any others.

Graeme