Transceiver Issue or Not - Australia
Posted: 25 Aug 2017, 03:58
New to forum but not novice. I have purchased a Tranceiver from Jaycar ZW3102 - image attached. I have provided power to it and connected data pin to pin 19 (also tried 17) on Mega. On the upload tool I see the initialization then nothing else.
With the exact same setup - Tranceiver and Mega (pin2), I am able to receive data from the Arduino rc-switch library. I am testing with a Bauhn power-outlet transmitter.
On the RFlink Uploader I have both logging and application-logging running. When I push a button on the remote control I see no activity at all. Even if the device is not recognized, should I see something?
I realize that the crappy Jaycar receiver is NOT on the hardware list but I assumed that if rc-switch made sense of the signal then RFLink should show something??????
Any Aussies out there?
With the exact same setup - Tranceiver and Mega (pin2), I am able to receive data from the Arduino rc-switch library. I am testing with a Bauhn power-outlet transmitter.
On the RFlink Uploader I have both logging and application-logging running. When I push a button on the remote control I see no activity at all. Even if the device is not recognized, should I see something?
I realize that the crappy Jaycar receiver is NOT on the hardware list but I assumed that if rc-switch made sense of the signal then RFLink should show something??????
Any Aussies out there?