I have running an 434Mhz set on an Arduino Mega 2560 board without any problem, but I try to run an second set with an 868Mhz (Aurel Tranceiver RTX MID 868.3 OOK) but when I run the RF Link loader and check the monitor I see:
Code: Select all
20;00;Nodo RadioFrequencyLink - RFLink Gateway V1.1 - R47;
10;version;
20;01;VER=1.1;REV=47;BUILD=08;
10;status;
20;02;STATUS;setRF433=ON;setNodoNRF=OFF;setMilight=OFF;setLivingColors=OFF;setAnsluta=OFF;setGPIO=OFF;setBLE=OFF;setMysensors=OFF;
10;rfdebug=on;
20;03;RFDEBUG=ON;
10;rfudebug=on;
20;04;RFUDEBUG=ON;
Because i'm not receiving anything.