Now, I have a MilLight RGBWW FUT015 bulb (RGB CCT it is called I believe?) with a FUT092 remote.
I use RFLink "20;02;VER=1.1;REV=48;BUILD=04;"
Using the "RFLink Loader v1.11" I'm trying to replicate all the remote "button" functions.
I've been successful in all of them, except switching to the "white" mode.
When sniffing the remote's messages RFLink displays it as a "set brightness" command.
Remote, setting Warm white
Code: Select all
20;13;MiLightv1;ID=20215A;SWITCH=04;RGBW=00c1;CMD=BRIGHT;
20;14;MiLightv1;ID=XXXXXX;SWITCH=04;RGBW=00c2;CMD=BRIGHT;
20;15;MiLightv1;ID=XXXXXX;SWITCH=04;RGBW=00c3;CMD=BRIGHT;
20;16;MiLightv1;ID=XXXXXX;SWITCH=04;RGBW=00bf;CMD=BRIGHT;
20;17;MiLightv1;ID=XXXXXX;SWITCH=04;RGBW=00c4;CMD=BRIGHT;
Code: Select all
20;18;MiLightv1;ID=XXXXXX;SWITCH=04;RGBW=009d;CMD=BRIGHT;
20;19;MiLightv1;ID=XXXXXX;SWITCH=04;RGBW=009e;CMD=BRIGHT;
20;1A;MiLightv1;ID=XXXXXX;SWITCH=04;RGBW=009b;CMD=BRIGHT;
20;1B;MiLightv1;ID=XXXXXX;SWITCH=04;RGBW=0099;CMD=BRIGHT;
I read somewhere that you need to send the "ALLON" command, but that doesn't work either.
What is the command to switch to "white" mode?
Below a list of commands I successfully used:
Code: Select all
//Lamp 4 on
10;MiLightv1;XXXXXX;04;0000;ON;
//Lamp 4 off
10;MiLightv1;XXXXXX;04;0000;OFF;
//Lamp modes
10;MiLightv1;XXXXXX;04;0000;MODE0;
10;MiLightv1;XXXXXX;04;0000;MODE1;
10;MiLightv1;XXXXXX;04;0000;MODE2;
10;MiLightv1;XXXXXX;04;0000;MODE3;
10;MiLightv1;XXXXXX;04;0000;MODE4;
10;MiLightv1;XXXXXX;04;0000;MODE5;
10;MiLightv1;XXXXXX;04;0000;MODE6;
10;MiLightv1;XXXXXX;04;0000;MODE7;
10;MiLightv1;XXXXXX;04;0000;MODE8;
//Slower
10;MiLightv1;XXXXXX;04;0000;DISCO-;
//Faster
10;MiLightv1;XXXXXX;04;0000;DISCO+;
//Set to color (light green)
10;MiLightv1;XXXXXX;04;6c90;COLOR;
//Minimum brightness
10;MiLightv1;XXXXXX;04;0085;BRIGHT;
//Maximum brightness
10;MiLightv1;XXXXXX;04;00fb;BRIGHT;