Hi all,
to test my König alarm system SAS (120) with remote, pir's and door contacts i have bought an RFLink 433 (next to the RFLink 866 and RFXcom 433 i already had). The alarm sensors are listed in the supported (receive) hardware list.
However i can'see them in the device list. Already disconnected the rfxcom and Rflink 866 to rule out interference but that doesn't help. I tried the "allow new hardware" button, debug mode in domoticz and from windows. Though when creating a signal from the sensors or remote, an orange led on the rflink 433 arduino blinks.
Also it seems the RFXcom shows much more signals in domoticz than the RFlink.
Anyone an idea, advice or similar experience?
Thanks
Jazzle
Picked up signals/ König alarm system sensors and remote
Moderators: rtenklooster, Voyager, BertB, Stuntteam
Picked up signals/ König alarm system sensors and remote
Domoticz @ Raspberry Pi 3 - RFXcom @ 433MHz - RFLink @ 868MHZ - ESP8266
Re: Picked up signals/ König alarm system sensors and remote
Make a debug log as explained here:
http://www.rflink.nl/blog2/development
http://www.rflink.nl/blog2/development
-=# RFLink Gateway Development Team #=-
Introduction: http://www.nemcon.nl/blog2/
Generic Support forum: http://www.esp8266.nu/forum/viewforum.php?f=8
Introduction: http://www.nemcon.nl/blog2/
Generic Support forum: http://www.esp8266.nu/forum/viewforum.php?f=8
Re: Picked up signals/ König alarm system sensors and remote
Thanks, email sent to Frank Zirrone
Domoticz @ Raspberry Pi 3 - RFXcom @ 433MHz - RFLink @ 868MHZ - ESP8266
Who is online
Users browsing this forum: No registered users and 47 guests