Hi. Today I flashed ESPEasy for the first time this year on a ESP-01 512k (blue).
It is up and running. Nice.
I try to do the following.
My alarm system switches from 12v to GND if set, and to 0v unset. Well that is interesting.
I want to capture this signal (voltage) and send it with a espeasy switch to my domoticz.
The 12v has to go down to 3v (buckconverter) to not blow up a GPIO input port.
So i started testing.
Created a switch device on GPIO2. Configured Domoticz Details , Virtual Switch On/Off etc etc
When connecting 3v to the GPIO2 pin it says SW: State 1 (Domoticz shows me alarm on), when disconnecting or connect to ground it say SW: State 0. (Domoticz sasys Alarm Off)
Well job done right ??
However... when I try to access the 'devices' tab of the ESP01 webinterface...
it reboots... All other tabs work just fine for configuration. Only when clicking devices it reboots.
Exception (0).
Devices tab reboots ESP-01
Moderators: grovkillen, Stuntteam, TD-er
Who is online
Users browsing this forum: No registered users and 76 guests