Read Write I2c Sensors

[berni50]

Hello,
is there a command to communicate transparent (read / write) to I2c-devices not in the supported device list ?
Without programming an new ESPeasy plugin.

e.g. If I build an own Arduino-I2C Slave Module and want to write or read registers in this Module.

The Module is a sun tracker, it calculate the current position of the sun based on the current date and time.
Than it drive two Servo#s for Azimut and Elevation and measure the power of an photocell with an INA219-Device.

Thanks berni50

[TD-er]

Nope there isn't, but I can see why you want it.
It might be something that could perhaps be done using rules? (not yet, just thinking out loud)