PWM, Value 1 to 5 flashes

[BerndJ]

Hi,

had a problem when i would like to use the PWM function by the above mentionend values. greater value 5 everything works fine.

is it a esp problem?

Idea: nice and a dream could be a dimming function, like:

Code: Select all

http://<ESP IP address>/control?cmd=Dim,<pin>,<Startlevel>,<Endlevel>,<time>

best wishes

Bernd

[asm7100]

Read the doc.

http://www.esp8266.nu/index.php/GPIO

[BerndJ]

Hi,

done, what did i not see?

http://<ESP IP address>/control?cmd=PWM,13,1

and also up to

http://<ESP IP address>/control?cmd=PWM,13,5

and the output Pin GPIO13 flashes, no constant level.

http://<ESP IP address>/control?cmd=PWM,13,0

and up of

http://<ESP IP address>/control?cmd=PWM,13,6

is OK.

Could anybody test it and confirm?

Bernd

[asm7100]

This one
http://www.esp8266.nu/index.php/GPIO

[BerndJ]

Sorry,

i must bee blind, do´nt see any solution regarding these problem on these site.

Take a resistor and a led, put it to one port and send the command with level 3 to this port.

Did u had a constant Light??

I had testet some boards, all of them have these problem, the led flashes.

If i send level 6 all is fine.

Where is the solution (pls don´t repeat yr answer for 3rd time) ?????