Sonoff 4CH with ESPEasy

[Methuselah]

viewtopic.php?f=5&t=5195#p27307

https://github.com/letscontrolit/ESPEasy/releases

[bphillips921]

The bottom sonoff is used to control a winch to automatically raise and lower the tower fixture (a TX-455 crank up, retrofitted with a KF9P hoist plate and harbor freight 2000 lb hoist (see https://www.youtube.com/watch?time_cont ... TQiq-WGNFE). One relay is used to power on and off the hoist w/ 120vac (switching the hot wire), and two relays are used to select up or down motion (by directing current to one of two wires).

Sorry for the thread hijack, but I am also trying to connect a Sonoff 4ch Pro to that same Harbor Freight winch in order to automate a grain dryer. Any chance you can share your wiring schematic so I can see what wires on the winch are hooked to the Sonoff and where? I've figured out how to unspool the winch, but I can not figure out how I need to wire it to spool-in the winch. Any guidance you can give me would be VERY appreciated.

Here's more info on what I'm working on.

https://community.home-assistant.io/t/n ... t/65100/28

Thanks!