ESP-01 V3 flashing issues

[Sprokkie]

hi,

i cannot get it working with domoticz.
flashed the firmware, see the configpages of the esp-01.
use the same settingas with some other esp module's and i cannot get the output switching,
got the correct idx and the gpio-0.

any thoughts ?

[grovkillen]

You need to connect the switch to ground since GPIO-0 needs to be set to high for boot.

https://www.letscontrolit.com/wiki/inde ... figuration

Or how do you connect it currently?

[Sprokkie]

connected it wit jumper wires on a bread board.
the CH_PCD connected with +
it boots because i see the lets controlit easy esp webpage.

it looks like it doesnt understand the command from domoticz : http://172.16.200.230/control?cmd=GPIO,0,1

[grovkillen]

Yes but how do you connect the switch? Will it (when closed) pull the value on GPIO0 down to ground?