I built, as a test, 2 sensors
- one with 2 DS18B20
- one with 1 x DHT22, 1 x Sitch (Motion Detector)
I´m using PiDome MQTT as the interface, but i don´t use PiDome Software, only Mosquitto as Broker
After a few hours both sensors stop sending values
They are still reachable by Web Interface, if i force a reboot, Values are sent again
In the log window, when sending no Values, i also don´t see the values / sensors
Any suggestions to solve this ? what are the available log levels ?
Regards
Klaus
No Values after a few hours
Moderators: grovkillen, Stuntteam, TD-er
Re: No Values after a few hours
I think loglevel 4 will show everything.
I had the same problem with domoticz MQTT so went back to HTTP.
I thought it was just me as it was the first time i had used MQTT.
Also when i switched back to HTTP it bricked the ESP so i had to re flash it from scratch.
I had the same problem with domoticz MQTT so went back to HTTP.
I thought it was just me as it was the first time i had used MQTT.
Also when i switched back to HTTP it bricked the ESP so i had to re flash it from scratch.
Re: No Values after a few hours
My module running R43 with OpenHAB MQTT have been connected to my mosquitto broker for daysrmtucker wrote:I think loglevel 4 will show everything.
I had the same problem with domoticz MQTT so went back to HTTP.
I thought it was just me as it was the first time i had used MQTT.
Also when i switched back to HTTP it bricked the ESP so i had to re flash it from scratch.
- Jan
Jan Chrillesen, Denmark
Who is online
Users browsing this forum: No registered users and 43 guests