Let's Control It

I'm trying to get one of these units working, and managed to get into the configuration panels and change some settings.
Unfortunately something must have gone wrong typing the new PW, since I cannot log in any more. The unit did change the IP address to match my network, so some of the changes were actually made.

No worries, a factory reset will bring me back to the basic. But how? I tried the description on the web, but no result.
Does anyone know how to do this?

grovkillen wrote: ↑03 Oct 2018, 17:54 https://www.letscontrolit.com/wiki/inde ... t_the_unit

This reders to an ESP, I assume.
The module I was terugging with is another type.
Meanwhile, with the help of Remco, I found out what was wrong. I will put a description and warning in the build description (OTGW with UTP interface).

manjh wrote: ↑03 Oct 2018, 20:10

grovkillen wrote: ↑03 Oct 2018, 17:54 https://www.letscontrolit.com/wiki/inde ... t_the_unit

Meanwhile, with the help of Remco, I found out what was wrong. I will put a description and warning in the build description (OTGW with UTP interface).

How did you regain access to your USR-TCP-232-T2? Where can I find that build description?