ESPEasy - Device=PushButton - Delays of feedback [ISSUE FIXED]

[papperone]

Check this setting in tools/advanced menu:

Message Delay (ms):

defaults to 1000 but can be lowered. This could be the delay that you're experiencing.

Thanks Martinus, that was it! I admit I've never realize there was such parameter in the Advanced Tab.
FYI bringing it to 0 did not work as the button behaviour was faster but unstable, with lots of false event.
With tome trial&error I set it to 100ms, really stable and button reacts real time even with multiple pushes one after the other!

Thanks again, I'll update the title as issue is fixed

[Domosapiens]

Thanks Martinus for this explanation.
I thought this variable was related to MQTT only.

Some of my DS18B20 have an update rate of 500msec (close to the heater), so I tried to lower the message delay to 400msec.
The result was a very spiked memory usage: from normal operation 20300 bytes down to spikes of 14200 and even 12600.
Can you understand why? Is it something to worry about?

Martinus, what will happen with the measurements made every 500msec when the messages to the controller are send only every 1000msec?

@papperone: did you check your memory usage with the 100msec setting?
Thanks
Domosapiens

[papperone]

Thanks Martinus for this explanation.
I thought this variable was related to MQTT only.

Some of my DS18B20 have an update rate of 500msec (close to the heater), so I tried to lower the message delay to 400msec.
The result was a very spiked memory usage: from normal operation 20300 bytes down to spikes of 14200 and even 12600.
Can you understand why? Is it something to worry about?

Martinus, what will happen with the measurements made every 500msec when the messages to the controller are send only every 1000msec?

@papperone: did you check your memory usage with the 100msec setting?
Thanks
Domosapiens

I did and I saw no differences... this setting, in my case, was only affecting the reactiveness of some devices (swtiches) that's it...