PowerDown command

Moderators: grovkillen, Stuntteam, TD-er

Post Reply
Message
Author
Zodiac69
Normal user
Posts: 85
Joined: 13 Jun 2016, 17:20

PowerDown command

#1 Post by Zodiac69 » 28 Apr 2018, 13:01

I do not see any "PowerDown" commands that one can send the ESP unit before you "Pull the Plug" on it.
I had an instance where i had to unplug my unit and after that it was just sending garbage out the serial port, had to re-flash it to work again.

Anyone else that think this is an good idea or is it not needed?

Post Reply

Who is online

Users browsing this forum: No registered users and 4 guests