set GPIO state other than 0 or 1

[TungstenE2]

I can set GPIO state by command to other values than 0 or 1.

Even this state is not shown in the list of devices (it stays 1) the status is stored.

Does this have any negative side effects?

Would like to use this for state controlling and request state by URL.

gpio2.jpg (21.93 KiB) Viewed 1886 times

gpio2.jpg (21.93 KiB) Viewed 1887 times

thx

[fraeggle]

Normally a GPIO has two states, 0 and 1. Anything else don't make any sense and will not work. Only in PWM-Mode you have a value from 0 to 1023, that is why only 0 and 1 is shown within GPIO-State.
I don't really understand "Would like to use this for state controlling and request state by URL."
What exactly do you want to control? Why Dummy Device with GPIO? Do you use IOBroker,MQTT...?

Peter