Hello from Belgium

Moderators: rtenklooster, Voyager, BertB, Stuntteam

Post Reply
Message
Author
haschi
New user
Posts: 2
Joined: 08 Nov 2017, 20:48

Hello from Belgium

#1 Post by haschi » 08 Nov 2017, 21:51

hi,
i discovered some while ago Domoticz. Superbe program.
Found the time to play with it since 2 weeks.
Still a lot to learn but with all available forums help is not difficult to find.
I have studied electronics and program since 30 years.
Already used raspberrys and arduinos in other projects.

Bought until now the following :
raspberry 3, some kaku switch modules, rflink arduino 433 and a 868mhz board, a razberry2 pcb, ....
waiting for the new Thermostaatkraan Spirit from Eurotronic, a nodoMCU (esp8266) module.
Searching for some switch Touch modules like Vhome, Itead (i have the impression that they are all the same but with a diff firmware) ...etc.

You see still a lot to test but i like the combination of pure electronics and programming.

I have a problem / question for the moment so i posted a first topic in the 'RFLink Support Forum - RFLink: Hardware Related discussions' section.

See you,
Hans

DeNB3rt
Normal user
Posts: 120
Joined: 15 Dec 2015, 14:07

Re: Hello from Belgium

#2 Post by DeNB3rt » 21 Nov 2017, 17:36

welcome! Where are you from (in Belgium ;-) )
Located in Belgium, Bruges. Working on a full DIY domoticz setup with ESPEasy.

Post Reply

Who is online

Users browsing this forum: No registered users and 12 guests