WIFI AP or STA mode detection within rules

[jgrad]

Is it possible to detect either ESPeasy device is running in AP (accessPoint) or in STA (station) mode? if yes, how (example welcome).

[jgrad]

Hi, I think we havent understood what I am looking for.

After you flash ESP8266 device with ESPeasy SW device starts in AP mode (SSID=ESP_0), you connect to this SSID and configure ESPeasy device to connect to one of available WiFi networks. Then ESPeasy reboots and starts in station mode (STA) connected to previously selected SSID.

If WIFI network, which was configured before is down for particular time (around 10min) ESPeasy goes to AP mode and starts broadcasting its own SSID=ESP_<esp NAME> until:
* either previously configured WIFI SSID is back again
* either you connect to ESPeasy SSID and reconfigure WIFI settings and reboot device

I am asking if there is any parameter within rules available to show in which mode ESPeasy is currently operate.

[maluko]

i think that you may want is like this example:

- run scenes/switch by controller timer, but when goes controller goes off will run the clock rules by Espeasy, its like that?

this is a feature that i if came will do myself happy