Send all values of dummy device to controller

Moderators: grovkillen, Stuntteam, TD-er

Post Reply
Message
Author
alabama
Normal user
Posts: 90
Joined: 24 Nov 2017, 10:04

Send all values of dummy device to controller

#1 Post by alabama » 12 Nov 2018, 13:41

I use FHEM as a controller. But while all values of a real device are sent to the controller (e.g. Temp. and Hum. of the DHT22) only the first value of the four I used in my dummy is sent. One workaround will be to use four dummies, but that's not the good solution.

Is this a bug of the software or a failure from me?

User avatar
grovkillen
Core team member
Posts: 3621
Joined: 19 Jan 2017, 12:56
Location: Hudiksvall, Sweden
Contact:

Re: Send all values of dummy device to controller

#2 Post by grovkillen » 12 Nov 2018, 13:57

You set the dummy to be either the default single unit (1) or something else. In your case I'd believe a quad sensor is the correct setting.
ESP Easy Flasher [flash tool and wifi setup at flash time]
ESP Easy Webdumper [easy screendumping of your units]
ESP Easy Netscan [find units]
Official shop: https://firstbyte.shop/
Sponsor ESP Easy, we need you :idea: :idea: :idea:

alabama
Normal user
Posts: 90
Joined: 24 Nov 2017, 10:04

Re: Send all values of dummy device to controller

#3 Post by alabama » 12 Nov 2018, 13:58

Of cause You are absolute right - my stupid failure :oops:

Post Reply

Who is online

Users browsing this forum: No registered users and 3 guests