GPIO Save Last Status to Boot State
Posted: 22 Oct 2017, 21:25
Hello All,
How can we configure the ESPeasy firmware to remain the any GPIO output on the last status it has before a power cycle goes Off then On.
Is their any specific rule or is should be done in the configuration, i tried the GPIO Boot State options without results, every time the power goes Off the GPIO 12 i uses on the relay goes Off after the power goes On again.
thank you,
How can we configure the ESPeasy firmware to remain the any GPIO output on the last status it has before a power cycle goes Off then On.
Is their any specific rule or is should be done in the configuration, i tried the GPIO Boot State options without results, every time the power goes Off the GPIO 12 i uses on the relay goes Off after the power goes On again.
thank you,