Let's Control It

Hello

I have Becker blinds with motors like "Becker Rohrmotor Funk P9-C01 - P9/16C PROF+ - 9 NM". (https://www.caliso.de/becker/rohrmotor- ... -9-nm-4897)
These are radio engines
The communication is at a frequency of 868 MHz

So...

I wanted to buy RFLink 868.3 OOK Gateway componenten (https://www.nodo-shop.nl/nl/rflink-gate ... enten.html) but I do not know if it will work with my motors.

On page : http://www.rflink.nl/blog2/devlist not found any backer motors .

I want everything connect to my Domoticz system.

Can anything help me in this matter ?

Hi,

I have a remote from Becker (Centronic EasyControl EC545) to operate my blinds.
I am also eager to know if the RFLink is working with the remote/receivers?

Thank you in advance!

Hello
I have TC4410-II for my blinds.

I bought rf-link 868 from https://www.nodo-shop.nl/en/rflink-gate ... nents.html with antenna.

I'm trying to do anything. For now in serial port i have many information, but I do not understand them very much ;(

Hello, I too would like to build an 868MHz RFLink to use Domoticz to control Becker motors.
Can anybody help with how one can go about developing this?