Let's Control It

Hello

I have a problem with the PCA 9685 module.
The module is recognized in the I2C list under the address 0x40.
When I try to control a port nothing happens.
I have it with http: // http: //192.168.1.157/control? Cmd = pcapwm, 1.4095
tries.
Or under the menu tool the comand pcapwm, 2.4095.
Nothing happened there.

I would be happy if I could control LED's.

Best regards
Andre

Checked your syntax?

https://www.letscontrolit.com/wiki/index.php/PCA9685

PCAPWM,<pin>,<value>

Comma between <pin>,<value>
Leave out spaces?

Hello

I've got it now.
I have set the comma there had not happened yet.
Then I connected the LED GNG to PWM and V + to V + connected then it went.
Before, I had V + (LED) to PWM (board) and GND (LED) to GND (board).

Now I have to "only" still FHEM to bring the slider to control the LED.

Thanks for your help

André