8 posts • Page 1 of 1
If you need to monitor the battery of a battery driven unit you want to have VCC enabled. It must be done at compile time since it will take over the analog function internally.
If the variable output is "-1.0" it means that the VCC is not activated or that a reading has not been completed (could be due to incorrect cabling etc. etc.).
Ah, that's right. Will add that scenario to the wiki. Thanks!
But TD-er had offered, that he change the behavior of the 0-delay-value of the devices, that these will be published once to the controller !?
Ok, I will leave it as it is for now. It's only a notice... We'll have to do a complete update of the wiki when we release 2.1
Who is online
Users browsing this forum: Google [Bot] and 5 guests