Help switching time too short

Moderators: Voyager, BertB, rtenklooster, Stuntteam, grovkillen, TD-er

Post Reply
Message
Author
beeckmanso
Normal user
Posts: 1
Joined: 05 Jan 2019, 11:19

Help switching time too short

#1 Post by beeckmanso » 05 Jan 2019, 11:37

Hello World,

I use an ESP-01 with mega-20181220.

I have two switch between GND and GPIOs directly connected without other component resistor or capacitor
One Doorbell between GND and GPIO 0
One Door Contact between GND and GPIO 2

The Door Contact don't work every time, in case of the door is too quickly opened. I don't receive anything with MQTT.

Is it possible to correct this by computer code ?
Or do I have to correct this electronically ?

Thanks in advance

Olivier

User avatar
grovkillen
Normal user
Posts: 2585
Joined: 19 Jan 2017, 12:56
Location: Hudiksvall, Sweden
Contact:

Re: Help switching time too short

#2 Post by grovkillen » 05 Jan 2019, 13:57

It's hard to tell if it's a mechanical issue or if the signal is too short. Could you measure the signal? Denounce time would maybe be possible to use, if you lower this value, you could even try the pulse counter?
ESP Easy Flasher [flash tool and wifi setup at flash time]
ESP Easy Webdumper [easy screendumping of your units]
ESP Easy Netscan [find units]
Official shop: https://firstbyte.shop/
Sponsor ESP Easy, we need you :idea: :idea: :idea:

Post Reply

Who is online

Users browsing this forum: Bing [Bot] and 5 guests