OutputHelperDevice

From Let's Control It
Revision as of 16:23, 10 August 2016 by Admin (talk | contribs)
(diff) ← Older revision | Latest revision (diff) | Newer revision → (diff)
Jump to navigation Jump to search

When using Domoticz MQTT protocol, we cannot configure direct commands to control output. Instead, a json message is send by Domoticz on the Domoticz/Out channel. We need to configure the IDX value within ESP Easy and link this to a given output pin. We usage a special 'helper' device to link IDX to GPIO.

You only need to set the IDX and the corresponding GPIO pin.