Thanks chaps,got it going.
Dave,thanks for the explanation of how this input works,makes sense now,

Thanks for the reply,
delay is set at 15 seconds but even after much longer than that value is not updated in web interface.
Will try reflashing device next.

I have an ESP-03 setup to read a DHT sensor and a PIR motion detector using ESP Easy R108. The DHT sensor works fine on various GPIO inputs but the switch value stays on 0 on any GPIO whether pulled high or low. Device is switch input IDX = 100 GPIO = GPIO-0 Pull Up ticked Switch Type = switch Switc...

Afternoon chaps,
Glad I found this firmware for ESP,really easy to setup and well laid out !
Have a few ESP modules set up on veroboard to play with home automation using openHAB and a pi.