I havent got it with me at the moment, but from memory it was a wdt reset, rst cause:4, boot mode (3,6) would do that every 5 seconds or so. Yes this is with the device sitting on the bench plugged into my laptop via usb cable, nothing connected to any of the pins. Flashing it as 1024 memory size ge...

Hi, I have two DS18b20's, one I think the temp is correct or within 1 degree, but the other is reading too high by about 5 degrees. It would be roughly 22 degrees in this room but the device is reading 27 degrees currently. Both temp sensors are wired the same, they get ground, 3.3v, and data goes t...

Hi,

Yes I tried that already. I cant send any commands over serial, shorting rx and tx for a few seconds when first giving power does nothing either.

Hi, On GPIO 0 and 2, I have two reed switches between ground and the input pin. One reed switch is mounted under a normal door with a magnet on the bottom of the door, that works fine, the other is mounted next to where a sliding door closes, with a magnet on the side of the sliding door. Its just a...

Hi, I seem to have bricked mine too touching GPIO 9.... Ive spent 5 or so hours trying to fix it and finally thanks to this thread I kinda have it working.. So far the only thing that has worked is to flash it set to 1024 instead of 4096. After flashing with memory size 1024 it works... I can set it...