Hi guys, Some help needed here. I'd like to control my Marantz receiver, but the code is not recognized so obviously I will have to use RAW. I've read the complete post but I'm somehow lost how to convert to correct string. Could someone help ? first Key Unknown encoding: F5EEEEC8 (32 bits) Raw (32)...

Thanks a lot for the help, spent last few figuring out what's wrong

I have also issues compiling with the _P111_RF.ino included. I tried reinstaling the IDE + removed the libraries folder and only included the ones from the ESP Easy distribution.

Still the same, any other ideas?

maybe a tip what could help as I never had issues with light I ordered one of these cheap smoke detectors off ebay, removed the crap and installed the ESP and MHZ19 into it.. working fine. http://www.ebay.com/itm/Fire-Smoke-Sensor-Detector-Alarm-Tester-Home-Security-System-Cordless-LOT-EP-/172322507...

I'm on ESP12E. ok, eventually got it working. The rule is as simple as this: on Lightswitch#value do SendToHTTP 192.168.2.4,39989,/cmd?a=motion_esp05_1 endon The Switch is configured as pullup / reversed / push button active high and the gpio is connected to a PIR sensor. working absolutely fine for...

Thanks a lot, I've seen similar topics to that based on which I also built the rules. I'm still struggling, I think the issue is with triggering the switch on gpio 16. What I have not is a pushbutton soldered to ground, effectively grounding GPIO16 when I push the button, still the switch is still h...

hi all, I'm trying to use a simple pushbutton to turn a LED on locally for testing purposes but having hard times achieving it. I have a LED connected to gpio 12 and a push button on pgio 16. I already tried a lot of combinations of the switch configuration but still struggling. (tried both bringing...

Hi Mijn.Handen, I have a similar setup than you but I'm fighting with the PIR. I would like to send a HTTP request from ESP when the PIR triggers, the issues I have: - There is a delay between triggering the PIR and ESP recognizing it - What is the configuration of the SWITCH in ESP for PIR ? Thanks...

so tried it with an rxb12 off ebay, no luck.

Could someone recommend what receivers are supported?

I just flashed an ESP 07 today.

what I did
connected 3,3V to VCC and EN
grounded GND GPIO15 & GPIO00

flased the firmware with the provided flasher, make sure you have the correct port & flash size (1M for esp07).

hope it helps.

+1
Would be useful.

renearts wrote:Wow, this looks great. I'll have a try with a RXB6 receiver and sender kit I have.
If this works well I might be able to get rid of my homeduino

any luck with testing ?

hello,

Is it possible to change the text size on SSD1306 somehow?


Thanks,
hugo.

I agree - ordering a few more 12E/ F units for now.

hi guys,
feedback, just built the co2 sensor with mhz19. so far (2 days) working fine with the code from playground. I set the power to 3.6V and power both the sensor and esp from one supply. thanks a lot to the developers.

hi,
anyone tested this module with this FW?

hello,
I work in IT and IoT is my hobby. I appreciate the hard work of the community, thanks guys. So far 4 sensors are up running.