I tried quite a few of the commonly available 433Mhz antennas (short/long rubber stubs, mono-poles with-/without ground-plane,...). For my constellation, the simple dipole works best (e.g. from nodo-shop, also available form china) https://www.nodo-shop.nl/en/antennes/102-antenne-433mhz-3dbi-sma-mal...

Done

https://github.com/letscontrolit/ESPEasy/issues/439

CherAlban

Hi, yes of course those glitches have a reason, in this case the whole poor optical setup and especially the reflective properties of my 50 years old Ferraris disc, which is hard to influence... I am using one of those little breakout boards, incl. a trimmer on it. There is no analog filtering imple...

Hi, I am reading my Ferraris electric meter using a cheap tcrt5000 IR sensor, triggering on the rising edge, created by the end of the red-section of the rotating disc. The setup is not really hassle free, as I am getting additional triggers, caused by very short glitches. I am already using the &qu...

I tried again with R43, as the DO26 is in the list of supported devices, but it gives the same strange behavior as with R46.

I am having the exact same problems as described above.

@Stuntteam: Do you need more logs or anything else we could help with?

CherAlban

I have multiple of these devices working out of the box with RFLink R46 and Domoticz without any problems. The devices change their IDs each time the batteries are removed. >>One arrived last night, Sadly it does not work straight from the box. It seems like sometimes the devices do not create a new...

I have the FORECUM doorbell, but can't get it to work with Domoticz and RFLink. I want to activate the doorbell from within Domoticz, instead of using the original push-button. Could somebody please explain to me how I can get RFLink to replay the captured sequence below? CherAlban 20;09;DEBUG;Pulse...

psy0rz wrote: ↑29 May 2017, 23:03 Should we add an option that activates the internal pullup for the DHT?

If that is a reasonable replacement for an external pull-up, I would appreciate that option very much.

CherAlban

It is a 1024 x 8 bit organized SPI flash chip, firmware with 1024 size is correct

Thanks for clarifying this, which brings us back to the original question, why does OTA fail on 1M devices?

CherAlban

I might be wrong, but I think the S20 has an ESP 8285 instead of a EPS 8266.

I just opened one and checked: they use an ESP8266EX and an external BN25F08, which for the latter I could not find any datasheet or documentation.

CherAlban

Hi,

I am running v2.0.0-dev8 on multiple Sonoff S20s using 'ESPEasy_v2.0.0-dev8_normal_1024.bin'. When trying to do an OTA with the same file, i get an 'Update Failed', and the device reboots with all settings reset. Is this a bug, or will OTA not be possible on 1M devices in the future?

CherAlban

Hi,

is there any way to update "Protected Switches" in Domoticz?

CherAlban

Hi, I am also struggeling with the rules. I am using Domoticz with espEasy R145 on an ESP8266-12F with a relay on GPIO-4 to control my car pre-heating. What I try to implement is: - When triggered from Domoticz (preheat20), espEasy shall close the relay for 20 minutes, and after opening it again rep...