Sorry for the cryptic description.
I want to have an pwm output so I can control an fan based on an pwm output.

Hello, I'm trying to get an PWM output with the last firmware 20102 - Mega. Because i want to control an fanspeed based on an temp. input i must use the Regulator - Level Control. I have setup the temp sensor as input and use GPIO13 (D7) as PWM output, only i see in the overview when the temp. is lo...

Hi,

Question, is there an wiki or work description how you can decode from unsupported devices the received info?

Ok, good to know.
An is there an command to use to check everything is working ok?
Because I send knowing from knowing devices but see nothing
----
Small update, I have (re) solder al the connections and it's now working.
Think that there was an bad connection.....

Hi, I have running an 434Mhz set on an Arduino Mega 2560 board without any problem, but I try to run an second set with an 868Mhz (Aurel Tranceiver RTX MID 868.3 OOK) but when I run the RF Link loader and check the monitor I see: 20;00;Nodo RadioFrequencyLink - RFLink Gateway V1.1 - R47; 10;version;...

Hello, I want to try to receive some info from an renkforce rf 101 smoke sensor. When i check the freq. it should be send something on 433,92mhz but when i set the RFlink software (windows) in the debug mode i see nothing on my screen. Is there something i can check if this combination is working? I...

Question, I have read on the website that there is maybe coming some support in the firmware for the NRF905 - 868 module.

Is this already implemented?