Any updates on this? Were you able to build this? I am looking to do the same.

Cool! Can I ask you if you have a wiring scheme for the NodeMCU + the LED strip?

Hi Duci, Thanks for your messages, this is very much what I would like to achive too, as I am about to learn some InfluxDB in order to leverage the Grafana dashboards like you said. Have you progressed any further in your project? MQTT works well for me, but I have not yet tackled the MQTT-to-Influ...

Replying to myself.. but for the next person wanting to do this: In the config page I set the protocol to OpenHAB MQTT and set "Locate Controller" and "Controller Port" with the address and port of my MQTT server. Then you setup your device (IDX/Var does not seem to matter) and i...

Hi guys, Fairly new to ESP2866 tinkering and electronics in general, but I have had some good success with ESPeasy in combination with Domoticz so now I have had the taste I would like to try the following. I hope you can give me a push in the right direction. :) I have in my network a MQTT server r...

Thanks for the suggestion on Domoticz. Do you know if it supports legacy devices like X10? I have a lot of these devices still working beautifully after 20 years. I assume that is 433mHz RF, correct? I have some COCO stuff around the house and have an RFXcom transceiver connected to my system (a Ra...

manjh wrote:Check out Domoticz, as domotica server..

Agree! I use it, and can confirm it to be inexpensive, and it integrates a lot of different technologies nicely (such as Zwave, RFlink/RFXcom, but also ESPeasy, of course. )