Now I got it working. I tried an other MAX6675 module and that worked. So the other module might have been broken. Nice!

Next part is connecting an display.

W.

Must still over-see something I guess. Now I get this:

Ok the hardware tab is now showing the SPI part. Give it a try later-on Thanks.

So I can still use this _P120_Thermocouple.ino sketch?

Ok. Can not find that on Github only the master/ dev branche where is it located? Sorry I found it while sending this message This is the one? http://www.letscontrolit.com/downloads/ ... 47_RC8.zip

Hourly Build 2017/01/17 If that's the version (in the ReleaseNotes.ino it says R120 )? Could the problem also be that I have a regular esp 12f but arduino has NodeMcu 1.0 12e module? as a board ?

If I have a look at the hardware tab I do not see any SPI mentioned. So what do you mean. Gpio12 and Gpio14 ? or pin mode?

No I did not do that. Did not know that I was supposed to do that. So I will have a look. Might be the solution.

Any thoughts on this? Will give it a try connecting it to usb power.

W.

I just started to explore ESPEasy and it has a lot of possibilities. My second project is wiring up the MAX6677 to an esp8266 12f. I followed the samples and all the posts here on the board and ended up with an log file showing me: 5105189 : WD : Uptime 85 ConnectFailures 0 FreeMem 28352 5109843 : P...