Hi all, I am trying to make a temperature sensoring system for my electric smoker, so that I could connect that to my Domoticz system. I succeeded installing the newest MEGA firmware on my NodeMCU ESP8266 development board, and wired the MAX6675 to the board based on some instructions I found with r...

My RFlink stopped working in the spring, and now that I finally diagnosed the problem to be an Arduino Mega board that freezes after a short while ON (this was supplied by the Dutch seller of RFLink). I got a new Arduino-board and got the system working again. Anyways, there seemed to have been a fi...

Thanks, and sorry for the delay, I just replied to your email.

Hello, Did you get this sorted? I have the same kind of a challenge, my chinese motorized screen remote looks different, but presumably is similar on component level, it's got three buttons; up, stop, down. This is what the debug mode gives me: 20;3C;DEBUG;Pulses=74;Pulses(uSec)=30,90,60,450,60,450,...