Search found 7 matches
- 09 Feb 2017, 21:07
- Forum: RFlink: General Discussions
- Topic: RFLink MiLight codes to HEX code
- Replies: 8
- Views: 10186
Re: RFLink MiLight codes to HEX code
The brightness is controlled in 32 steps. Could you clarify this a little bit? By saying it's controlled in 32 steps do you mean 8,16,24,32... up to 256 in HEX or I get it completely wrong? I'm using RGBW FUT038 controller and I've tried this command '10;MiLightv1;F003;00;00FF;BRIGHT;' with no succ...
- 23 Mar 2016, 19:49
- Forum: ESP Easy: Software
- Topic: publishing switch state to the broker periodically - possible?
- Replies: 0
- Views: 1933
publishing switch state to the broker periodically - possible?
Like in the topic - Is it possible to make Sensor Delay work for a switch as well? I'm using build r85 - when I select "Send data" checkbox on a switch configuration page it sends state to the broker only once after gpio change, but it would be better if it would send it's state periodical...
- 03 Feb 2016, 07:51
- Forum: ESP Easy: Software
- Topic: espeasy won't publish data to mqtt broker
- Replies: 5
- Views: 5137
Re: espeasy won't publish data to mqtt broker
I'm testing r71 for a week on one of my sensors and I haven't noticed any mqtt problems so far
- 24 Jan 2016, 19:24
- Forum: ESP Easy: Software
- Topic: espeasy won't publish data to mqtt broker
- Replies: 5
- Views: 5137
Re: espeasy won't publish data to mqtt broker
Thanks for the reply. I'll put r71 on my boards and test it out.
- 22 Jan 2016, 09:36
- Forum: ESP Easy: Software
- Topic: espeasy won't publish data to mqtt broker
- Replies: 5
- Views: 5137
espeasy won't publish data to mqtt broker
Hello, I've noticed that sometimes ESPEasy goes into state where it won't publish data to mqtt broker (my other sensors publishes data at this time). I've tested builds nr 48 and 63 - both seems to have the same problem. I can connect to esp webserver and read it's log. It seems that it works OK, bu...
- 08 Nov 2015, 23:47
- Forum: ESP Easy: General Discussion
- Topic: problem with nodemcu devkit 1.0 and r39
- Replies: 5
- Views: 5916
Re: problem with nodemcu devkit 1.0 and r39
I figured out how to download r30 finally :) But thank you for the link. INIT : Booting Build nr:39 WIFI : Connecting... WIFI : No SSID! INIT : I2C INIT : Boot OK INIT : Normal boot Updating from r20 to r30 to r39 worked like a charm! Thanks for the suggestion. Does anyone have an idea why r39 doesn...
- 08 Nov 2015, 22:11
- Forum: ESP Easy: General Discussion
- Topic: problem with nodemcu devkit 1.0 and r39
- Replies: 5
- Views: 5916
problem with nodemcu devkit 1.0 and r39
Hello, I'm using Nodemcu devkit 1.0 (esp12e). When I flash version r20 everything works fine, but when I upload r39 I'm getting this: PID:0 Version:0 INIT : Incorrect PID or version! RESET: Reboot count: 0 ctx: cont sp: 3ffecae0 end: 3ffecd60 offset: 01b0 >>>stack>>> 3ffecc90: 00000002 4000410f 3ffe...