Search found 8 matches
- 08 Nov 2017, 14:05
- Forum: ESP Easy: General Discussion
- Topic: MQ2 smoke/gas detector support?
- Replies: 15
- Views: 22939
Re: MQ2 smoke/gas detector support?
Can someone tell if the CO sensor MQ-9 will work with 2.0 ?
- 15 Aug 2017, 21:35
- Forum: Introduce yourself
- Topic: Hello from NL
- Replies: 13
- Views: 10826
Re: Hello from NL
alright thanks, I will give it a try again. Also mailman dropped an aliexpress envelope with a dht22 am2302 sensor. The bme230 was almost 2 degrees warmer then it real was, maybe its own heat? Will the DHT22 more accurate? And which gpio can I use, just D2, I dont have it in use. And does that gpio ...
- 15 Aug 2017, 16:59
- Forum: Introduce yourself
- Topic: Hello from NL
- Replies: 13
- Views: 10826
Re: Hello from NL
Hi, it's working again. I resoldered the pins, the ground pin looked fragile.
But, still, should I connect both again without resriors or?
But, still, should I connect both again without resriors or?
- 15 Aug 2017, 14:54
- Forum: Introduce yourself
- Topic: Hello from NL
- Replies: 13
- Views: 10826
Re: Hello from NL
When the temp sensor connected, it is working well, so the ESP board seems to be ok (same gpio and 3v/g pins used)
I shall check the soldering of the pins, maybe is something not that good.
I shall check the soldering of the pins, maybe is something not that good.
- 14 Aug 2017, 21:57
- Forum: Introduce yourself
- Topic: Hello from NL
- Replies: 13
- Views: 10826
Re: Hello from NL
Hi, I connect both devices and both showing different address in the i2c scan. My bme280 is working fine, but my lux sensor is now giving wrong data. It is giving the full lux. It was working before. I am sure I connected the same wires on the same gpio. Edit, with only the bh1750 connected, it give...
- 14 Aug 2017, 12:44
- Forum: Introduce yourself
- Topic: Hello from NL
- Replies: 13
- Views: 10826
Re: Hello from NL
OK so I can already try first without resistors?
I don't have any yet.
I don't have any yet.
- 14 Aug 2017, 06:49
- Forum: Introduce yourself
- Topic: Hello from NL
- Replies: 13
- Views: 10826
Re: Hello from NL
Ok but will there be changes in the design as from the link you provided?
So connecting wires together is no problem?
by reading it triple times, it seams to be needed, 2 10kohm.
So connecting wires together is no problem?
by reading it triple times, it seams to be needed, 2 10kohm.
- 13 Aug 2017, 09:55
- Forum: Introduce yourself
- Topic: Hello from NL
- Replies: 13
- Views: 10826
Hello from NL
Hello from the netherlands. I am new here :) I've bought some nice things to try, and has already something working. A nodemce v3 board with a BH1750, it is controlling lights in combination with a presence detection in domoticz. My domoticz server is a rpi 3b, but before I had it running on my nas,...