Dear, rol-rider, All, I took the recent .bin file provided by rol-rider, configured HLW8012 with GPIO-5/-13-14 as described many times above. Needed to free up I2C GPIOs now to GPIO-1/-3. Power Factor and Power works fine after calibration. However, Voltage and Current remain in 0. Anybody any idea ...

Merci Beaucoup, Will try again A bientot

Thank you, Rol-rider. After flashing, I get errors with looping reset during boot: see below. Any idea why this happens? Anybody can reconfirm? Using a 4M Sonoff Pow. UART Messages: ets Jan 8 2013,rst cause:1, boot mode:(3,6) load 0x4010f000, len 1384, room 16 tail 8 chksum 0x2d csum 0x2d v09826c6d ...

Dear Papperone,

Would you mind to provide a link to the .bin file with the firmware you merged your updates into?
This would it make it easier to test and to provide further feedback.

Thank you for your great contribution to this topic.

Best
Homeautomator24