Thank you both.. I give v2.0 a shot based on your recommendation.

Hi,
Are there .bin files available for v2.0.0. I can't seem to find them, the only ones I can find are mega .bin's.

Regards
Sailesh

Hello all, I need some help. I have a Sonoff basic running espeasy. I wanted to be able to control the relay using a standard toggle wall switch (the UK kind), so i've extended Ground and gpio14 to the wall switch but I've also added a 4.7k resistor between 3.3 and gpio14. Its to control 8 LED down ...

After much reading, I found that I had to add a resistor between 3.3v and GPIO14, I soldered in a 4.7k resistor, and now all seems to be working perfectly.

Hi Yes, both switches are the latching (toggle) type and I've attached screenshots of the device settings. I've had a bit more of a play and the symtoms are strange. The light turns on/off just fine via http, The light turn on/off just fine using the main switch (switch closest to the light) The lig...

Hello everyone. I need help. I have installed a Sonoff basic in a 2 way switching setup. I can switch the light on/off over http, but when I use the physical switch, the Sonoff flicks on and off. I found a video on YouTube which explained the wording setup I took a snapshot and attached it. I have 2...

Oh my.... I plugged in serial and checked the output on putty.. I got nothing... Then just as I was going to try and reflash one of the units when it struck me.. I have an external toggle switch with a wire soldered to the push button on the unit.. so if the toggle was in the on position and the uni...

Hello all, I have 2 Sonoff WiFi modules with Esp easy wired into 2 bed side lamps.... Everything was working perfectly until 2 days ago when my wife said she noticed a very brief (around a couple of seconds) power cut or power disterbance. All my appliances are working fine but when I tried to turn ...

Is there much of a difference between R120 and 147?.....

Just an update.
Shorting tx/Rx didn't work for me.. I had to use the espTool from
Espressif. There is an option to clear the chip which worked. I then used Arduino IDE to load EspEasy on again.
Phew!

Oh and my unit also came from China... Took about 3weeks to deliver to my home in the UK.

Thanks Shardan
I'll give this a go when I get home. Incidentally...Do you have any idea what kind of response I should get from the on board LEDs when doing this?

Hello all I have a Sonoff S20 which I've read is almost identical to the Sonoff basic. I'm able to upload espeasy but as with others.. there's no AP. There's a twist to this story though... As I did manage to get it up before.. This is what happend: Tested the original unit with EWelink - all was ok...

+1 but also there are a few other things I would like to see implemented too 1) Masking of the WPA2 password 2) Use of HTTPs rather than HTTP (though I'm not sure if this is possible) re: KRACK the only thing I can think of to reduce the chances of this exploit happening, is to disable SSID broadcas...