nekely wrote: ↑23 Jan 2018, 13:13 now all switch works fine, I just need to try it with my veraedge

Works fine with my veraedge, send de command and status correctly modifing some the rules to send htpp commands

in the end I got it, thanks at first pressing the button would turn on, but turning it off at the time it was turned on again. After several tests I got it to work changing "normal switch" to "push button active low" these are the rules that you create on Boton1#Switch do if [Bot...

manjh wrote: ↑17 Jan 2018, 21:29 In the first piece of code, you're checking on the state of the switch. Should be the state of the gpio.

I'm sorry I did not see this message, I try it

nothing, with the new update they do not work either

I just put the last update today, I'll try it

version 2_3_0

this is the rule On Channel1#Switch do if [Channel1#Switch]=1 event,Channel1_On else event,Channel1_Off endif endon On Channel2#Switch do if [Channel2#Switch]=1 event,Channel2_On else event,Channel2_Off endif endon On Channel3#Switch do if [Channel3#Switch]=1 event,Channel3_On else event,Channel3_Of...

sorry ..., I had not restarted the sonoff.
now it works, but only the first time it turns on and off, then I press the button and it does not do anything

I have managed to operate the sonoff 4ch correctly, with ESP, what I do not get is that none of the physical buttons work.