okay thanks for your information. I couldn't find much information at the internet and i had tried a lot of possibilities. Can you tell me where i find the information about the topic and the payload? Depent it on the mqttbroker? Or is it in the ESPEasy configuration?

/Strassenlicht/cmd GPIO,13,1 is not working and

/Strassenlicht/cmd/GPIO,13,1 isnt working too...

So my mqtt command should be:
Strassenlicht/cmd GPIO,13,1?

This is not working. I had put my config in attachments and my try too

Hello, thanks for your reply! Yes, the http command works fine. I had tried more mqtt commands. From the wiki i think correct is this: /Strassenlicht/control?cmd=GPIO,13,1 But it doesn't work... Had tried this in mqttfx and this as a openhanded item: Switch switch1 "Strassenlicht" { mqtt=&...

Hello, i try to connect my espeasy devices with openhab. The openhab is on a rpi. I have install mosquitto and configured it already. I have set the configuration in the espeasy device. I can connect to the mqtt broker and i see the devices there if i make a subscribe over mqttfx. Now i try to chang...