Yes, you have to wait a bit longer..

http://www.rflink.nl/blog2/devlist
Centralis Uno is not listed and thus might not work..
In that case you need to check:
http://www.rflink.nl/blog2/development

check the wiring of the rf module

Een milight controller heeft 1 adres met 4 zones... bij 2 controllers kan je dan 8 lampen individueel aansturen.
RFLink heeft een vrij toe te wijzen adres en 4 zones. Je kan met 1 RFlink daardoor 262140 lampen individueel aansturen.

- Go to settings/hardware - Select "Create RFLink Devices" (if you do not have this option then update to a more recent [beta] version) - In the popup enter: 20;E0;NewKaku;ID=cac142;SWITCH=1;CMD=ON; this will create a device in Domoticz. Once that is done, put your receiver in pairing mode...

Both receivers will send pulses to the pin, the software will not know which module is providing pules

Use the rffind option to learn the devices.. that will solve the issue

Apart, wellicht een slechte kloon?

Welke deursensor is dat?

I would get an ethernet cable between the 2 locations and on each side an rflink.

No idea if it works better than an Aurel or RXB6..
I have one but did not have time to look at integrating it yet. For now priority goes to CC1101 and CC2500.
The CC2500 is already functioning properly.

The Nano is not important as we are not using that and will not be using it..

Model 50028 is not supported yet.
It uses scrambled communication and is not easy to implement.
We are working on a solution...hopefully soon..

You probably need a more recent Domoticz version

I think so..
Otherwise it will be fixed..

Forum Rules: 1.Posts are to be made in the relevant forum. Users are asked to read the forum descriptions before posting. 2.Members should post in a way that is respectful of other users. Flaming or abusing users in any way will not be tolerated and will lead to a warning or ultimately in being ban...

Since we had some jokers who thought it was fun to spam the forum, it was decided that the initial posts of new users had to be moderated. When one of the many moderators believes your intentions are good, your post is approved and your account will be unlocked. After that you can post without moder...

In Domoticz, the manual switch creationg has a test button. Pressing this button sends the ON signal.
You can press it multiple times to pair..

That is the 2.4Ghz version. It is not supported.
There is also a 433mhz version..

Btw, Rev35 is a bit old already

Hi Deennoo, Welcome