is there a way to check button ? when i hold it i hear "bip" but i tested tasmota and ther button1 doeasnt work too. i dont have backup of oryginal software so i cant check it

no but i checked all options. even if i use factory reset with predefined config for toucz t2, buttond one dont wanna to work :/

ps if i take wire and shorcut gnd to gpio0 (r19) then switch change state and i can see it on log

yes and activate low too, just wonder is it ok that after gpio-d3 i see "!"

just try everything ;) im new https://ibb.co/CVLbDJF https://ibb.co/cNBZRn6 rule1: on touch2#switch2 do if [touch2#switch2]=1 gpio,5,1 else gpio,5,0 endif endon rule2: on touch#switch do if [touch#switch]=1 gpio,12,1 else gpio,12,0 endif endon its my second day with sonoff and esp easy and i think i...

i found that before but cant set up like this
if i use http://192.168.100.203/control?cmd=GPIO,1,1 then it turn on again http://192.168.100.203/control?cmd=GPIO,1,1 turn it off, ok it depends if i check internal pull up but cant change state with touch

i found that gpio9 is switch2 gpio5 i relay2 gpio12 is relay1 13 is wifi led... i cant find switch1 gpio :/

Hi im new with easpeasy ;) i just get my first sonoff touch t1eu2c flashed with espeasy (after "some" time) but now i dont know how to configure hardware/devices. I found rules for sonofo basic etc but can someone help me with touch 2c ? i don't know how to set up buttons and relays :( whi...