Hello,
Sorry but i didn't find the way to read data from domoticz. I need to get two temperature sensors that have an idx.
It is reachable by http://mydomoticzip/json.htm?type=comma ... value=TEMP
Thank you
Search found 8 matches
- 28 May 2020, 21:21
- Forum: ESP Easy: General Discussion
- Topic: Read data from domoticz
- Replies: 3
- Views: 6220
- 24 Oct 2019, 14:00
- Forum: ESP Easy: General Discussion
- Topic: If statement
- Replies: 9
- Views: 9143
Re: If statement
So simple ? i spent hours on this.
THANK YOU
THANK YOU
- 24 Oct 2019, 10:48
- Forum: ESP Easy: General Discussion
- Topic: If statement
- Replies: 9
- Views: 9143
Re: If statement
On the emitting unit if i set a rule : on Capteur#Temperature do if [Capteur#Temperature] > 23 do // On éteint, trop chaud gpio,13,1 else // On allume, trop froid gpio,13,0 endif endon it works, and i see it in the logs. BUT the same rule on the receiving unit doesn't work. Capteur#Temperature is al...
- 24 Oct 2019, 10:40
- Forum: ESP Easy: General Discussion
- Topic: If statement
- Replies: 9
- Views: 9143
Re: If statement
On the 'emitting' unit :
- 24 Oct 2019, 10:37
- Forum: ESP Easy: General Discussion
- Topic: If statement
- Replies: 9
- Views: 9143
Re: If statement
yes. And as i said i see the temperature and it is updated every 30s as i asked. But i cant get the value in rules
- 24 Oct 2019, 09:52
- Forum: ESP Easy: General Discussion
- Topic: If statement
- Replies: 9
- Views: 9143
Re: If statement
I tried at the beginning. But it doesn't work. In fact it is Capteur#Temperature that is in fault. I read it from another unit, and it gets no value . If for example i do a taskValueSet with Capteur#Temperature, in the log there is a blank behind TaskValueSet 12,1, I have no idea how to get Capteur#...
- 23 Oct 2019, 22:56
- Forum: ESP Easy: General Discussion
- Topic: If statement
- Replies: 9
- Views: 9143
Re: If statement
One detail : i'm using global sync. Capteur#Temperature is on another Unit. Do i have do prefix if ? How ?
Thank you
Thank you
- 23 Oct 2019, 21:55
- Forum: ESP Easy: General Discussion
- Topic: If statement
- Replies: 9
- Views: 9143
If statement
Hello, sorry but it's minutes i can't get a solution. My if always goes to // On allume, trop froid even when EVENT: Consignes#Jour=23.00 EVENT: Consignes#Nuit=17.00 EVENT: Consignes#Hysteresis=1.00 EVENT: Consignes#Actuelle=23.00 EVENT: Capteur#Temperature=26.00 on Capteur#Temperature do if [Capteu...