Thank you,
I will try apply steps from you..
Search found 4 matches
- 25 Feb 2019, 08:33
- Forum: ESP Easy: Projects / Applications
- Topic: Seria Server - Ser2Net wiki?
- Replies: 13
- Views: 12096
- 22 Feb 2019, 08:48
- Forum: ESP Easy: Projects / Applications
- Topic: Seria Server - Ser2Net wiki?
- Replies: 13
- Views: 12096
Seria Server - Ser2Net wiki?
Hi, I spent lot of time but I still don't found good answer and Wiki are old without required info. I want to use arduino's analog inputs, measure values, make calculations and push it trough ESP to Domoticz MQTT but I still don't know how to do it.. how to make good serial communication.. for examp...
- 30 Jan 2016, 22:11
- Forum: ESP Easy: Software
- Topic: Suggestion - Signal Level in Domoticz
- Replies: 0
- Views: 2035
Suggestion - Signal Level in Domoticz
Hi, I have a suggestion - sending signal level to domoticz via json url request. It is required ,just add parameter &rssi= and value from 0 to 11 Will be required, do some calculation between WiFi signal level and domoticz signal level source: http://www.domoticz.com/wiki/Domoticz_API/JSON_URL%2...
- 29 Jan 2016, 11:10
- Forum: ESP Easy: General Discussion
- Topic: Why cannot GPIO_1 and GPIO_3 be used for I2C ?
- Replies: 2
- Views: 3391
Re: Why cannot GPIO_1 and GPIO_3 be used for I2C ?
Yes, I thinked about posibility to use GPIO01 and GPIO03, same as each other GPIOs.. Not only for I2C. In HW page will be setup, and after reboot will be disabled Serial output if one of pin have another setting then Default. I wanted to just hard change It in code, but this setting is deeper in ESP...