What is the value of the resistor you are using? And ho long is distance you are trying to transmitt? With the arduino that have about the double amount of current on each pin i have been able to transmitt around 4-6 meters with an IRled from a remote. Havent tried the ESP transmitter but the dista...

Hello everyone! Who can help me with this plugin https://github.com/ESP8266nu/ESPEasyPluginPlayground/blob/master/_P106_IRTX.ino ? I try to use NEC protocol, but still nothing not working. It's correct command for NEC: http://192.168.1.106/control?cmd=IRSEND,NEC,4FB40BF,32 ??? After send that comman...

Using GPIO 0 and GPIO 2 for I2C is a bit tricky. When using passive I2C listen devices like OLED or LCD there are no problem to be expected. When using devices like BH1750 and BMP085 you could end up in troubles because of the special status GPIO 0&2 have when starting up a ESP8266. These 'talk...

I made a mistake. I took IDX from "hardware menu". Correct IDX was in "devices menu".

some more people struggled over the idx-default with 0=no sending. and a 1+ hint for the idx-setting (0= no reading, 1-... start reading) http://www.esp8266.nu/forum/viewtopic.php?f=4&t=726&p=3458#p3462 Make sure there is an IDX/var not being zero as number http://www.esp8266.nu/forum/viewt...

Hi, ESPeasy will not send out data when you have not entered an idx for Domoticz in the device setup. To get the idx go to Domoticz. You already have two virtual hardware devices defined (test and virtual). Select one of these and push the 'create virtual sensors' button that will give you the poss...

Hi! I have some questions for you friends? please help: 1. The second day trying to set up the firmware, but nothing happens. Why esp8266 sees i2c sensors but not reads information from them? It can not be used gpio gpio 0 and 2 for the SCL and SDA? Data exchange between the server domotikz also not...

Hello everyone! :) "ESP Easy" a excellent project, well done! Today i found at on the shelf dusty ESP8266-01. I will try to use "ESP Easy" firmware. Pleasantly surprised that now ESP8266 has support for Arduino IDE. Continue in the same spirit, I wish you good luck! P.S. For the ...