Let's Control It

good afternoon,
I try to connect a warema sender with 8 channels. Under device it shows:
rflinki 00006CA7 0 oben 6 Light/Switch Warema Open
but it seems that all 8 channels have the same entry. Any hints?

thanks in advance Daniel

Check your email..

good morning,

i´ve got the same problem with my 8k hand transmitter, controlling my roller shutters.

In domoticz the control command is recognized as warema protocol, but it´s always the same address.

Do i have to pair the devices with my master control unit?

Check your email..

I also have a problem with warema EWFS
Rflink recognises the switches. But i cannot control with rflink.

Stuntteam wrote: ↑11 Feb 2017, 10:51 Check your email..

Hello,

I have the same problem.
Could you send me the information too?

Br,
tkospace

Hello,

I would be interested as well.
I have a Warema EWFS Weather Station Plus combined with an adapter to control an even older Warema awning.
I also have a handheld transmitter to manually move it out and in.
I managed to retrieve the commands for out and in using a Signalduino at 433 MHz and I can "replicate" them as raw messages so this works.
But I would be intested in the data of the weather station because it contains a wind and rain sensor.
And I would like to "see" when the weather station "commands" the awning to move out or in.

Thanks,
best regards
Richard

For new/unknown devices follow the instructions here: http://www.rflink.nl/blog2/development