Renkforce rf 101

Post here about devices that are not yet or not fully supported

Moderators: rtenklooster, Voyager, BertB, Stuntteam

Post Reply
Message
Author
Phoenix-Blue
New user
Posts: 7
Joined: 24 Dec 2016, 15:19

Renkforce rf 101

#1 Post by Phoenix-Blue » 05 Mar 2017, 21:36

Hello,

I want to try to receive some info from an renkforce rf 101 smoke sensor.
When i check the freq. it should be send something on 433,92mhz but when i set the RFlink software (windows) in the debug mode i see nothing on my screen.
Is there something i can check if this combination is working?

I'm using in my case an Aurel RTX MID 5v for the 433Mhz.
Regards,

Post Reply

Who is online

Users browsing this forum: No registered users and 13 guests